How to install a floppy disk drive. Updated: 0. 5/0. 5/2. Computer Hope. Buying tips and help. If you have not already purchased a floppy drive see the floppy buying tips section help before continuing. Note: This page is written for computers that have had an internal floppy disk drive. Newer computers and operating systems no longer support internal floppy disk drives. Tip: If you still need access to a floppy disk drive we suggest purchasing a USB floppy disk drive that is compatible with your version of Windows or Mac. How to determine the floppy drive type.
Before getting started. Write down important information from the top or bottom of the floppy disk drive such as the Model Number, Serial Number, and specifications. Ensure you are familiar with ESD and its potential dangers. ![]() When physically installing the standard floppy disk drive, ensure the computer is powered down and unplugged. Remove existing floppy drive. If you are installing a floppy disk drive to replace a faulty one, begin by disconnecting all cables from the current floppy drive and then remove it from the system. Most systems will require that a screw or set of screws be removed before the drive can be extracted. Other drives are attached to a removable bracket that can be pulled out by pressing and holding two tabs. Note: If you do not see screws, some systems may hold the drive with a screw on the front of the case. Help and information with installing a computer floppy disk drive. You can still install a Brother printer even if you've misplaced the installation CD-ROM. Jupiterimages/Photos.com/Getty Images. The Disk II Floppy Disk Subsystem, often rendered as Disk Install. Open the computer case and connect the floppy drive to the computer using screws or a bracket. Connect Cables. Once the new floppy drive has been connected into the computer, connect the floppy interface cable (small gray flat cable) to the back of the floppy drive. The floppy cable has a side with a blue or red side indicating pin number 1. This side of the cable will point to the power connection. If your computer floppy cable has three connections or a twist in the cable, ensure that the cable is connected properly by referring to the picture below. Today, most computers and computer floppy disk drives have cables that only have two connections: one for the motherboard and the other for the floppy disk drive A. If your cable only has two connections, the above picture does not apply. Once the floppy interface cable has been connected to the computer, connect the floppy power cable to the back of the floppy disk drive. This cable is a small power cable when compared to the other power cables coming from the power supply. Setup CMOSOnce the floppy drive has been connected to the computer, place the case back onto the computer and connect the keyboard, monitor, and power to the computer (we recommend that you do not connect all the cables yet, if problems are experienced you may have to disconnect all the cables again). Once connected, turn on the computer and enter CMOS setup. Verify that the floppy drive is properly setup within BIOS, most likely as a 1. How to Install Canon Wireless Printer (with Pictures)1. Remove all the protective materials and orange color tape outside the machine. Open the Paper Output Tray and lift the Scanning unit Cover. Remove protective material and orange color tape around Ink Cartridge Holder. Close the Scanning unit cover. Use Operation Panel to select the language, then press OK button. Open Scanning unit Cover. Insert Ink Cartridge Holder into the Holder. Close Scanning unit Cover. Wait a while for printer to adjust the Ink Cartridge. Use Operation Panel select Wireless LAN setup, then press OK button. Press OK button. Select Access point, press OK button. If Auto. Play screen not shown, go to the CD- ROM folder and right click Msetup. Then click Next. At the next page Click Install. Then click Next. It will take a while. When Printer Detection screen appears, click next. Now the setup is completed.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
August 2017
Categories |